Density Tester LDMT-A11

Labtron’s Density Tester LDMT-A11 is suitable for a wide range of non-corrosive liquids, including water-based solutions, oils, fuels, lubricants, and chemical reagents. It is especially useful in laboratories analyzing petroleum products, pharmaceutical solutions, and industrial fluids that require precise density measurements. The unit’s robust temperature-controlled bath and built-in stirrer ensure uniform temperature distribution for reliable results across different sample types. However, the use of highly corrosive or volatile substances should be avoided unless the setup is specially modified. Always confirm that the liquids are compatible with the materials of the bath and densimetry cylinders.

Our Density Tester LDMT-A11 is designed with two cylinders holders to allow testing of two samples at the same time under identical temperature conditions. This feature increases throughput, making it ideal for labs that need to analyze multiple samples or batches in a short time. It enables direct comparison between samples and reduces the need to repeat temperature settings for each test. This not only saves time but also improves workflow efficiency. The dual holders are easy to access and support the cylinders securely during immersion and removal.

The Density Tester LDMT-A11 features an easy-to-use control panel with indicator lights and adjustment knobs for both heating and stirring functions. These visual indicators provide immediate feedback on system status, helping users monitor bath conditions and respond quickly to any issues like overheating or unstable temperatures. The transparent bath allows full visibility of sample immersion, fluid behavior, and fluid levels during testing. This visual access enhances safety and helps catch operational errors early. Labtron’s user-friendly design reduces operator fatigue and ensures a smooth testing experience.

The Density Tester LDMT-A11 should be filled with a suitable high-boiling-point bath medium, such as silicone oil, when operating near its 100?°C limit to prevent excessive evaporation or splashing. Personal safety equipment like heat-resistant gloves and goggles should be used during handling to avoid burns. The tester must be placed on a stable, heatproof surface away from flammable materials. Our device is built for safe operation, but always allow the bath and glassware to cool down fully before removing samples or draining the fluid. If any irregularities occur like overheating or temperature fluctuation the device should be turned off and inspected immediately.

The Density Tester LDMT-A11’s bath medium should be maintained based on the type of fluid and frequency of use. Water should be replaced weekly or after heavy use to avoid scaling, microbial growth, or contamination. Oil-based media can be used longer but should still be inspected weekly and replaced monthly or when it appears dirty or degraded. After draining, the bath should be wiped clean using a soft cloth and mild detergent to maintain hygiene and thermal efficiency. Keeping the bath clean ensures optimal heating performance and protects both the sample and equipment over time.