Automatic COC Flash & Fire Point Tester LOFP-B10

Labtron’s Automatic COC Flash & Fire Point Tester LOFP-B10 may produce distorted flash point readings or trigger unsafe ignition if the sample contains water, dust, or volatile impurities. These contaminants can lead to premature flashing, erratic flame behaviour, or even damage to internal components. The sample must be homogeneous, clean, and properly prepared as per standard testing protocols. The tester delivers accurate results only when clean samples are used.

Our Automatic COC Flash & Fire Point Tester LOFP-B10 allows users to input the expected flash point before beginning the test, enabling the system to optimize the heating ramp and flame timing. This predictive programming reduces unnecessary preheating time and helps prevent sample degradation. The flame is automatically introduced near the anticipated flash temperature range. This feature is especially useful for routine testing of known substances.

The Automatic COC Flash & Fire Point Tester LOFP-B10 uses an electric ignition system, so if the flame fails to ignite, users should first verify the functionality of the ignitor and ensure that any fuel source (if required) is correctly connected. Check for damage or obstruction in the ignition wire or electrode. Moisture buildup or low fuel pressure can also interfere with ignition. It includes diagnostic prompts, and persistent issues should be referred to the manual or technical support.

The Automatic COC Flash & Fire Point Tester LOFP-B10 provides reliable results when samples are clean, dry, and thoroughly mixed before testing. Proper placement of the test cup and checking the ignition system for faults are important pre-test steps. Users should avoid exposing the tester to drafts or external airflows that could disrupt the flame. The built-in barometric correction and parameter presets help reduce variation caused by environmental conditions.

The Automatic COC Flash & Fire Point Tester LOFP-B10 is equipped with digital alerts and error messages that notify users of critical conditions such as over-temperature, ignition failure, or internal system errors. Our interface guides users step-by-step through preheat, ignition, and result capture. The unit automatically stops operation when unsafe conditions are detected, minimizing risk. These built-in alerts enhance operator safety and protect the device during use.